Messages

Next: The Commands in Detail Previous: Notation Up: The Editor and Its Commands

Messages

Basically, all messages and error messages a command can produce are listed in the description of the specific command, like this:

message, exaEdit

All these messages appear in the index of this manual, where instead of message the actual message is listed.

Additionally there is the chapter The exaEdit Messages , which is an extract of the index limited to the messages only.

The exception of these rules are some messages generated by many commands. Accordingly many entries in the index and the messages chapter would not be all too informative. These messages are explained in the messages chapter without page references, while their index entries refer to the according page in the message chapter and to the current page.


Begin column larger than end column    

Begin of data                          

Character string too long              

End of data                            

Number too large                       

Parameter variable no character string 

Parameter variable not defined         

Parameter variable not numerical       

SET storage invalid                    

SET storage unused                     

There is no next record                

There is no previous record            

There is no column 0                   

You cannot ... the top line

And finally there are some error messages that have reasons so obvious that probably nobody would want to read the complete command description:


Command in error: ...       

Number 0 not allowed        

Operand missing in: ...     

Parameter missing           

There is no such command    

Wrong parameter

Therefore their entries in the index and in the message chapter refer to the current page only.

Next: The Commands in Detail Previous: Notation Up: The Editor and Its Commands