END|QUIT E|Q
The command END finishes the editor. In advance to the finishing, it is checked whether you made changes in the existing workfiles. If this is the case, you are informed about it and you have a chance to continue the exaEdit session to save the changed workfiles onto a disk.
If there is only the workfile MAIN in the exaEdit session, you receive the message
Changes not savedPress J or Y to stop:In line mode, the second line is:
Enter J or Y to stop:If there are other workfiles as well, the message reads instead:
Workfiles not saved: ...Instead of the ... the workfiles concerned will be listed.
If you decide not to save the changes, you press the key
`j' or `y' (small letters or
caps) and the editor is stopped immediately. Contrasting, if you
press any other key, the processing of the command END
stops and you can go on editing as usual.
Please, note that it is sufficient to press a key to answer the question whether you want to leave the editor. It is not necessary to press the return key afterwards.